background image

CLEANING PROCEDURES 

 

1.  After all food products have been removed from the cabinet, turn the 

power switch to “OFF” and allow the cabinet to cool. 

2.  Unplug the unit prior to any cleaning. 

3.  Grease/crumb pan is located beneath the unit, inside the cabinet. 

Access by opening cabinet door. Remove and clean the grease / 
crumb pan from the bottom of the unit by sliding it out towards the 
operators side of the unit.  Clean the pan as well as pan housing. 

4.  The air filter can be easily removed without tools for cleaning by lifting 

up and pulling towards the front of the unit. Clean by hand washing or 
run through an automatic washer.  Reinstall when filter is dry and 
clean. 

5.  Remove the product dividers and food bay bottom.  Clean the inside 

of the unit as well as the removed parts. Reinstall when all parts are 
dry and clean. 

6.

 

Inspect and clean the areas where there are vents, making sure no 
water gets into the internal controls or electrical areas of the cabinet. 

 

Product Divider 

 
 

Food 
Bay 

 
 
 

Cleansers, detergents, degreasers, sanitizers, or bleaching agents that contain chlorides or phos-

phates will cause permanent damage to stainless steel products.  The damage appears as pits, erup-
tions, voids, small holes, severe discoloration or dulling of the metal finish.  Water with high chlo-
ride content can also damage stainless steel.  If unsure of your water quality, we recommend you 
have it tested.  THIS DAMAGE IS PERMANENT, COSTLY TO REPAIR, AND IS NOT COV- 

ERED BY THE WARRANTY

.

 

RECOMMENDED TIPS FOR CLEANING STAINLESS STEEL 

 

Purpose 

Frequency 

Cleaning Agent 

Method of Application 

Routine 

Daily 

Soap, ammonia 

Sponge with cloth, rinse with clear water 

cleaning 

detergent and water 

and wipe dry.

 

 

Smears/ 

As 

Stainless steel cleaner 

Rub with soft cloth as directed on package. 

Fingerprints 

needed 

or similar products 

Rub in direction of grain of stainless steel. 

Do not use on vinyl trim. 

 

Stubborn 

Daily 

Any chloride-free 

Apply with damp sponge or cloth. Rub in 

spots and 

as 

or 

direction of grain of stainless steel.  Rinse 

stains 

needed 

phosphate-free 

thoroughly, especially if cleaner contains 

cleaner 

chlorine bleach, do not use on vinyl trim. 

 

Hard water 

Daily 

Vinegar 

Swab with cloth. 

spots 

as needed 

Rinse with water and wipe dry. 

 

7

Grease/crumb pan

Removal of air filter

CAUTION: 

ELECTRIC SHOCK 
HAZARD 

Disconnect appliance from 
electric power before cleaning. 

 

CAUTION: 

HOT SURFACE 

Exposed surfaces 

can be hot to the touch and 
may cause burns.  Allow appli-
ance to cool before cleaning. 

IMPORTANT: 

DO NOT 

spill or pour water into controls, 
control panel or wiring.  Water 
damage is 

not 

covered by 

warranty. 

CAUTION: 

Beware of sharp 
edges on sheet 

metal during cleaning,  espe-
cially during removal of grease 
filters. 

CAUTION 

Содержание CRISP N' HOLD PCF14











Отзывы: