II. Installation
1. Host
a.
Insert SIM card in alarm system
Press the yellow point on the unit with a pencil tip or other tools, SIM
card tray will come out. Put the SIM card into the tray and make sure
the Metal contacts of the card to be downwards, and then push the
tray back.
Before inserting SIM card in the alarm unit, using a regular mobile
phone do the following steps:
---Set PIN code request to off
---Delete all stored numbers
b. Connect the antenna
Screw
the antenna to the unit carefully; do not over-tighten the nut
or leave it too loose!
c. Connect the power supply
Plug the alarm system into power and turn on the power switch. The
signal status LED on the unit will turn red and last for 20 seconds. This
shows it’s waiting for wireless detectors to be coded into the unit. Then
the status LED will turn orange with flash, indicating the unit is checking
the SIM card and searching for GSM network. After checking, if the LED
changes to green with slow flash, it shows phone numbers have been
saved in the unit, and the unit is now in “Arm” status. If the LED keeps in
green, it means phone numbers have not been saved in the unit, and
the unit is in “Disarm” status, you can call in or send SMS to program
the phone numbers.
