39
Symptom
Broadcast stations cannot be se-
lected automatically.
No sound from surround or center
speakers.
Cannot be remote controlled.
Cause
• Weak radio signal.
• Incorrect center mode.
• The surround and/or center levels
are turned down.
• The surround and/or center
speakers are disconnected.
• The remote control unit batteries
have worn out.
• Too far away or bad angle of
operation.
• There is an obstacle between the
receiver and the remote control.
• Strong light such as fluorescent
light is shining onto the unit's
remote control signal light-
receiving window.
Remedy
• Connect an outdoor antenna (see
page 7).
• Set the correct center mode
according to the speakers in your
system (see page 13).
• See Setting Volume Levels on
page 15-16 to check the speaker
levels.
• Connect the speakers (see pages
11-12).
• Replace the batteries (see page
6).
• Operate within 7 m, 30° of the
remote sensor on the front panel
(see page 6).
• Remove the obstacle or operate
from another position.
• Avoid exposing the remote sensor
on the front panel to direct light.
If the unit does not operate normally due to external effects such as static electricity
¶
Disconnect the power plug from the outlet and insert again to return to normal operating conditions.
Additional Information
