Connect network
08
22
A: Connecting with a LAN cable (wired
LAN)
Simply connect the LAN cable. Network settings are
unnecessary.
• When wireless LAN is set once, the following procedures
1 through 3 must be executed.
1
Select “Network Type Set” from the HOME
MENU.
2
Use
/
to select “Wired”.
3
Press ENTER.
A-1: Wired connection to a router with DHCP
server
1
Confirm that this unit is powered off.
2
Use a LAN cable to connect this unit and
your router.
3
Press
STANDBY/ON.
Wait for about 30 to 40 seconds.
4
When the power is fully turned on, the
NETWORK indicator will light white.
A-2: Setting this unit from the web browser of
a computer that supports a wired LAN
connection
• Only when connected to a network without a DHCP
server function, the following network settings are
necessary. Check the setting value with the provider or
network administrator in advance when executing the
settings. Also refer to the user’s manual for network
equipment.
•
IP Address
The IP address to be entered must be defined within the
following ranges. If the IP address defined is beyond the
following ranges, you cannot play back audio files stored
on components on the network or listen to Internet radio
stations.
Class A: 10.0.0.1 to 10.255.255.254
Class B: 172.16.0.1 to 172.31.255.254
Class C: 192.168.0.1 to 192.168.255.254
•
Subnet Mask
In case an xDSL modem or a terminal adapter is directly
connected to this unit, enter the subnet mask provided
by your ISP on paper. In most cases, enter 255.255.255.0.
•
Default Gateway
In case a gateway (router) is connected to this unit, enter
the corresponding IP address.
•
Primary DNS Server/Secondary DNS Server
In case there is only one DNS server address provided by
your ISP on paper, enter it in the “
Primary DNS Server
”
field. In case there are more than two DNS server
addresses, enter “
Secondary DNS Server
” in the other
DNS server address field.
•
Proxy Hostname/Proxy Port
This setting is required when you connect this unit to the
Internet via a proxy server. Enter the IP address of your
proxy server in the “
Proxy Hostname
” field. Also, enter
the port number of your proxy server in the “
Proxy Port
”
field.
1
Turn off power to the unit.
If a LAN cable is connected to the unit, disconnect the LAN
cable from the unit.
2
Use a LAN cable to connect the unit to the
computer.
3
Press
STANDBY/ON.
Wait for about 30 to 40 seconds.
4
Wait for the NETWORK indicator to change
from flashing to steadily lighted red.
This may require up to 90 seconds or so.
5
When the NETWORK indicator lights red,
start your computer’s Web browser, and access
the URL noted below to make settings for this
unit.
The Web Control menu will appear.
http://169.254.1.1
SBX-B70D.book 22 ページ ２０１５年４月１３日 月曜日 午後２時６分
