12
En
Installation Procedure
4
Raising the lock bar and pulling the bot-
tom of the plasma display forward.
Pull out the bottom of
the plasma display.
Raise the
lock bar
(either the
left or the
right side).
5
Raising and removing the plasma display.
Raise and remove the plasma display.
When removing the plasma display
1
Loosening the screw on the tilt adjust-
ment metal fitting.
Note
Removing the plasma display without removing the tilt ad-
justment metal fitting may scratch the wall.
Before beginning this procedure, turn off the power
to the plasma display and peripheral devices and re-
move their power plugs from the outlets. As neces-
sary, also remove connecting cables.
2
Removing the push rivet and the anchor
screws that are holding the lock plate, and
the anchor screws that are holding the
PDP metal fitting (2 locations: left and
right sides).
Anchor screw
Push rivet
Lock plate
Anchor screw
3
Unlocking the lock bar (2 locations: left
and right sides).
Lock
bar
Set the lock bar in its unlocked
position
Caution
Unlocked
position
Locked
position
Pull out the bottom of the plasma display very
carefully so that the hook on the PDP side
metal fitting is not displaced.
Caution
Always have at least 2 people do this task.
Caution
