9
En
Checking the Parts
Check the parts before beginning assembly.
Note
Screws used to fix the wall-hanging metal fitting firmly to
the wall surface are not included. Purchase these separately.
Philips driver separately.
Operating instructions
(this document) x 1
Service Parts List
Installation Procedure
1
Removing the push rivet of the lock plate
and the bottom anchor screw (M6 x 14mm)
(2 locations: left and right sides).
1
Move the push rivet of the lock plate to its unlocked
position so the lock plate is in the condition shown in
the figure.
2
Remove the anchor screw from the bottom.
2
Releasing the lock bar (2 locations: left and
right sides).
Hung on wall unit x1
Tilt adjustment metal fitting x1
Hexagon wrench x 1
(Opposite side 6 mm for M8 use)
Bolts M8 x 6
Stencil x 1
取扱説明書
Operating instructions
Mode d’emploi
Bedienungsanleitung
Istruzioni per l’uso
Gebruiksaanwijzing
Manual de instrucciones
壁掛け型プラズマディスプレイ金具
HUNG ON WALL UNIT
ECRAN MURAL
WANDBEFESTIGUNGSEINHEIT
UNITA
'
DA PARETE
EENHEID VOOR WANDBEVESTIGING
UNIDAD PARA COLGAR DE LA PARED
PDK-WM01
「据付工事」について
本機は十分な技術・技能を有する専門業者が据え付けを
行うことを前提に販売されているものです。据え付け・取
り付けは必ず工事専門業者または販売店にご依頼くださ
い。
なお、据え付け、取り付けの不備、誤使用、改造、天災な
どによる事故損傷については、弊社は一切責任を負いま
せん。
Lock plate
Push rivet
Lock bar
Anchor screw (M6 x 14mm)
Set the lock bar in the
unlocked position.
Unlocked
position
Locked
position
Pull the
push
rivet
Note
Be careful not to lose the 2 anchor screws (M6 x 14mm)
because they will be used later.
Unlocked
position
Locked
position
Mark
No.
Description
Parts No.
BOLT M8
AZB1435-
SCREW M6
AZB1438-
PACKING SET
AZH1158-
OPERATING INSTRUCTIONS
AZR1074-
TILT ADJUSTMENT
AZR2560-
METAL FITTING
Lock
bar
