Pioneer NO FOUND VSX-1020, Руководство по эксплуатации

Страница: 81 / 260

Controlling the rest of your system 09
81
En
English
Français
Deutsch
Nederlands
Italiano
Español
5 Repeat steps 3 to 4 to program a
sequence of up to five commands.
If you press R.SETUP before programming is
completed, commands programmed up to that
point will be stored.
6 Press R.SETUP to exit the programming
mode.
Using multi operations
1 Press MULTI OPERATION.
The LED flashes continuously.
2 Within five seconds, press an input
function button that has been set up with a
multi operation.
The receiver switches on (if it was in standby)
and the programmed multi operation is
performed automatically.
Using System off
1 Press MULTI OPERATION.
The LED flashes continuously.
2 Within five seconds, press

SOURCE.
The command sequence you programmed will
run, then all Pioneer components will switch
off
1
, followed by this receiver (switch of all the
zones becomes off).
Erasing all the settings for the multi-
operation
This erases all the settings programmed in the
remote control for the multi-operation.
1 Press and hold the R.SETUP, press “8” for
three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP
.
2 Press the input function button
containing the program you want to cancel or
the

SOURCE button for three seconds.
If the LED lights for one second, the erasing
has been successfully completed.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes
are sent.
VSX-1020_UC.book 81 ページ ２０１０年１月７日 木曜日 午後６時０分