Pioneer KFDH100, Инструкция по установке, эксплуатации и обслуживанию

Страница: 4 / 16

2.3 Installing indoor unit
2.3.1 Unit suspension
Indoor Unit Installation
Outdoor Unit Installation
• Use the hanging rods to hang the unit through the holes provided. Strength of hanging rods must be
able to support the total weight of the unit.
• Add isolator, absorber , if necessary , to minimize the vibration transmission to the ceiling.
2.3.2 Drain pipe
• Drain pipe shall be properly installed for the
drainage for the drainge of condensate water.
• Trap shall be installed (See figure 2.3)
• Make sure no leak at the connecting joint.
Trap
• Insulate the drain pipe to avoid water condensation.
Model A B
3.1 Unit dimensions , Installation location
Liquid Line
Gas Line
• In order to optimize capacity, unit shall be installed
as recommended requirements :-
a) Allow sufficient space around the unit, to avoid
the recirculation of the hot discharge air.
b) Ensure no obstruction air flow into or out of the unit.
c) The location which is well ventilated.
d) A place protected from direct sunlight, use an
awning for protection, if necessary.
e) A place where the hot air discharge and operating
sound level will not annoy the neighbours.
f) A place must not be susceptible to dust or oil mist,
or other corrosive chemicals
Caution:
• Avoid installing at location containing oils (including
machine oils), salt (coastal area), sulphide gas (near
hot spring, oil refinery plant), corrosive chemicals etc.
OBR15x35
1156
1220
1160
985
8x 50
30
80
700
143
275
70
143
Fig 3-1 KODH
3