Pioneer KFDH100, Инструкция по установке, эксплуатации и обслуживанию

Страница: 2 / 16

1. Safety Precaution
1
2. Indoor Unit Installation
2.1 Outline dimensions,
Installation location
2.2 Service Space
2
2.3 Installing the indoor unit
2.3.1 Unit suspension
Contents
Safety Precaution
Before installing the unit, make sure you read all the “Safety precautions”.
Warning:
Describes precautions that must be observed to prevent danger of injury or death to user.
Describes precautions that must be observed to prevent damage or malfunction of the unit.
Caution:
Notice:
• Installation and maintenance should be perform
-ed by qualified personnel.
• Avoid direct contact with sharp edges and coil
surfaces
• Ensure the condensate drain pipe is properly
installed.
• DO NOT overcharge the equipment
• Avoid long piping installation
• The equipment installation and electrical work
must comply with local codes and regulations.
• The unit must be securely installed on structure
that can sustain its weight.
• If installed in a small room, measures must be
taken to prevent refrigerant concentration
exceeding the safety limit in case of gas leak.
Warning:
Caution:
• After installation , check for the system leaks.
DO NOT use Oxygen, Acetylene, poisonous or
any flamable gas for the leak test.
• End user should not attempt to repair the unit
in case of malfunction or failure.
• This manual should be read carefully before installation. Unit installation and service should be performed
by experienced technicians in accordance with manual’s procedures to achieve normal and reliable unit
operation.
• This manual should be kept and returned to unit’s designated place after installation is completed
for reference.
2.3.2 Drainage pipe
3
3. Outdoor Unit Installation
3.1 Outline dimensions,
Installation location
3
3.2 Installation Space & cleatance
4
3.3 Installing the outdoor unit
4
4. Refrigrant Piping connection
5. Vaccuming and Charging
5
4.1 Piping length
5
4.2 Piping connection
5
5.2 Refrerant Handling
6
6. Electrical Wiring
6
7. Controller Operation
8. Test Run
12
9 Service and Maintenance
13
10 Trouble Shooting
14
8
1