1
Route battery wire from engine com-
partment to the vehicle interior.
!
When drilling a cable pass-hole into the ve-
hicle body and routing a battery wire thor-
ough it, take care not to short-circuit the
wire damaging it by the cut edges or burrs
of the hole.
After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the amplifier to the positive (
+
) battery
terminal.
2
1
3
1
Positive (
+
) terminal
2
Battery wire (sold separately)
The maximum length of the wire between
the fuse and the positive
+
terminal of the
battery is 30 cm.
3
Fuse 100 A (GM-D8601) / 150 A (GM-D9601)
(sold separately)
Each amplifier must be separately fused at
100 A (GM-D8601) / 150 A (GM-D9601).
2
Use wire cutters or a utility knife to
strip the end of the battery wire, ground
wire and system remote control wire to ex-
pose about 10 mm of the end of each of
the wires, and then twist the exposed ends
of the wires.
Twist
10 mm
3
Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
3
6
1
5
4
2
7
1
Battery wire
2
Power terminal
3
Ground wire
4
GND terminal
5
System remote control wire
6
System remote control terminal
7
Terminal screws
Connecting the speaker output
terminals
1
Use wire cutters or a utility knife to
strip the end of the speaker wires to ex-
pose about 10 mm of wire and then twist
the wire.
Twist
10 mm
2
Connect the speaker wires to the
speaker output terminals.
Fix the wires securely with the terminal
screws.
1
3
2
1
Terminal screws
2
Speaker wires
3
Speaker output terminals
En
9
English
Section
03
Connecting the units
