10
PRO-1000HD / PRO-800HD
Installation and Connections
Connection of G ON SYNC analog RGB source
Make G ON SYNC connections for a component with
output that has the synchronization signal layered on top
of the green signal.
When connecting to INPUT1
On screen setup is necessary after connection.
Please see pages 18 and 19.
When connecting to INPUT2
On screen setup is necessary after connection.
Please see pages 18 and 19.
Note
When making G ON SYNC connections, do not make any
connections to the VD or HD terminals. If connections are made,
the picture may be not displayed normally.
Connection of composite SYNC analog RGB
source
Make composite SYNC connections for a component
with output that has the vertical synchronization signal
layered on top of the horizontal synchronization signal.
When connecting to INPUT1
On-screen setup is necessary after connection.
Please see pages 18 and 19.
When connecting to INPUT2
When using INPUT2, set the impedance selector switch
to match the output impedance of the connected
component’s synchronization signal.
When the output impedance of the component’s
synchronization signal is below 75
Ω
, set this switch to
the 75
Ω
position.
On-screen setup is necessary after connection.
Please see pages 18 and 19.
Note
When making composite SYNC connections, do not connect
anything to the VD terminal. If connected to, the picture may not
be displayed properly.
ANALOG RGB
(ANALOG RGB)
INPUT1
OUTPUT
G
B
R
HD
VD
(ON SYNC)
(H/V SYNC)
Ô
75
2.2
Ω
k
Ω
INPUT2
ANALOG RGB
(ANALOG RGB)
INPUT1
OUTPUT
G
B
R
HD
VD
(ON SYNC)
(H/V SYNC)
Ô
75
2.2
Ω
k
Ω
INPUT2
