Initial Settings
Setting the rear output and sub-
woofer controller
This unit’s rear output (rear speaker leads out-
put) can be used for full-range speaker (
Rear
SP:FULL
) or subwoofer (
Rear SP:S.W
) connec-
tion. If you switch rear output setting to the
Rear
SP:S.W
, you can connect a rear speaker lead
directly to a subwoofer without using an auxil-
iary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL
).
When rear output are connected to full range
speakers (when
Rear SP:FULL
is selected), you
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass
filter, phase) built-in
S.W Control:INT
or the
auxiliary
S.W Control:EXT
.
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 67) or subwoofer output
(refer to page 66) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1 Press
F
to select
SW
.
Press
F
repeatedly until
Rear SP
appears in the
display.
• Pressing
FUNCTION
on the head unit also
performs the same operation.
2 Change the rear output setting with
E
or
e
.
Pressing
E
or
e
will switch between
Rear SP
:FULL
(full-range speaker) and
Rear SP :S.W
(subwoofer) and that status will be displayed.
• Pressing
5
or
∞
on the head unit also per-
forms the same operation.
Notes
• When no subwoofer is connected to the rear
output, select
Rear SP:FULL
.
• When a subwoofer is connected to the rear
output, set for subwoofer
Rear SP:S.W
.
• When the rear output setting is
Rear SP:S.W
,
you cannot change the subwoofer controller.
3 Change the subwoofer controller with
1
or
¡
.
Pressing
1
or
¡
will switch between
S.W
Control :INT
and
S.W Control :EXT
and that
status will be displayed.
• Pressing
2
or
3
on the head unit also per-
forms the same operation.
En
82
11
Section