1 Press A and hold until FRONT appears
in the display, then press A to select
T TONE.
After
FRONT
is displayed, press
A
until
T TONE
appears in the display.
2 Press
n
to start the test tone output.
The test tone is output. It rotates from speaker
to speaker in the following sequence at inter-
vals of about two seconds. The current set-
tings for the speaker over which you hear the
test tone are shown in the display.
FRT-L
(front speaker left)
CENT
(center
speaker)
FRT-R
(front speaker right)
RER-R
(rear speaker right)
RER-L
(rear speaker left)
SUB.W
(subwoofer)
#
Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the test
tone.
#
The settings do not appear for speakers
whose size is set
OFF
.
3 Press
r
or
q
to adjust the speaker
output level.
Each press of
r
or
q
increases or de-
creases the speaker output level.
+10
10
is
displayed as the level is increased or de-
creased.
#
The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Press
m
to stop the test tone output.
5 Press BAND to return to the playback
display.
Notes
!
If needed, select speakers and adjust their
ab-
solute
output levels. (Refer to
Adjusting the
speaker output levels
on the previous page.)
!
To adjust the speaker output levels at this
mode is the same as making the speaker out-
put levels at
FRT-L
. Both provide the same re-
sults.
Adjusting the time alignment
By adjusting the distance between each
speaker and a selected listening position, you
can insert delay times into the speaker output
to obtain a correct sound image and overall
level balance. Although this is automatically
achieved when you set the listening position,
the time alignment feature provides a fine ad-
justment.
1 Press A and hold until FRONT appears
in the display, then press A to select FL.
After
FRONT
is displayed, press
A
until
FL
ap-
pears in the display.
#
You cannot select
FL
when neither
F/L
nor
F/R
is selected in
POSI
.
2 Press
m
or
n
to select the speaker
to be adjusted.
Each press of
m
or
n
selects the speaker
in the following order:
FL
(front speaker left)
C
(center speaker)
FR
(front speaker right)
RR
(rear speaker right)
RL
(rear speaker left)
SW
(subwoofer)
#
You cannot select speakers whose size is set
OFF
.
3 Press
r
or
q
to adjust the distance
between the selected speaker and the lis-
tening position.
Each press of
r
or
q
increases or de-
creases the distance.
500.0
(cm)
0.0
(cm) is
displayed as the distance is increased or de-
creased.
4 Press BAND to return to the playback
display.
Digital Signal Processor
En
63
Section
12
Digital
Signal
Proces
sor
