Pioneer DVH-P435UB, Руководство пользователя

Страница: 28 / 36

DIN Rear-mount
1 Determine the appropriate position
where the holes on the bracket and the
side of the unit match.
2 Tighten two screws on each side.
1
2
3
1
Truss screw (5 mm × 8 mm)
2
Mounting bracket
3
Dashboard or console
Removing the unit
1 Remove the trim ring.
1
Trim ring
2
Notched tab
!
Releasing the front panel allows easier ac-
cess to the trim ring.
!
When reattaching the trim ring, point the
side with the notched tab down.
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3 Pull the unit out of the dashboard.
Removing and re-attaching the
front panel
You can remove the front panel to protect your
unit from theft.
For details, refer to
Removing the front panel to
protect your unit from theft and Re-attaching
the front panel on page 9.
En
54
Section
05
Installation
Troubleshooting
Common
Symptom Cause Action (Reference page)
The power will not turn on.
The unit will not operate. Leads and connectors are incor-
rectly connected. Confirm once more that all connections are
correct.
The fuse is blown. Rectify the cause and then replace the fuse.
Be sure to install a fuse with the same rating.
Noise and/or other factors are caus-
ing the built-in microprocessor to
operate incorrectly. Turn the unit off and then on. (Page 9)
Operation with the remote con-
trol is not possible.
The unit does not operate cor-
rectly even when the appropriate
remote control buttons are
pressed. The remote control operation mode
is incorrect. Switch to the correct remote control mode.
(Page 8)
Battery power is low. Load a new battery.
Some operations are prohibited
with certain discs. Try operating with another disc.
Playback is not possible. The disc is dirty. Clean the disc. (Page 60)
The type of disc loaded cannot be
played on this unit. Check the disc type.
The disc loaded is not compatible
with this video system. Change the disc to one that is compatible
with your video system.
There is no sound.
The volume level will not rise. Cables are not connected correctly. Connect the cables correctly.
The unit is performing still, slow mo-
tion or frame-by-frame playback. There is no sound during still, slow motion or
frame-by-frame playback.
The icon is displayed, and op-
eration is not possible.
The operation is prohibited for the
disc. This operation is not possible.
The operation is not compatible
with the configuration of the disc. This operation is not possible.
The image displayed stops
(pauses) and the unit cannot be
operated. The data could no longer be read
during playback. Stop playback once, and start playback again.
There is no sound.
The volume level is low. The volume level is low. Adjust the volume level.
The attenuator is on. Turn the attenuator off.
The sound and video skip. The unit is not firmly secured. Firmly secure the unit.
File size and transmission rate are
above recommended rates. Create a DivX file that is within the recom-
mended size and transmission rate.
The aspect ratio is incorrect and
the image is stretched. The aspect ratio setting is incorrect
for the display. Select the appropriate setting for your display.
(Page 26)
The motor sounds when the
ignition switch is turned ON (or
is turned to ACC). The unit is confirming whether or
not a disc is loaded. This is a normal operation.
No xxxx appears when a dis-
play is changed (
No Title
, for ex-
ample).
There is no embedded text informa-
tion. Switch the display or play another track/file.
En
55
Appendix
Additional
Information
Additional Information
<QRB3172-A/N>28