22
04
Section
En
Installation
Connecting the unit
WARNING
• To avoid the risk of accident and the
potential violation of applicable laws, no
viewing of front seat video should ever
occur while the vehicle is being driven.
• In some countries or states the viewing
of images on a display inside a vehicle
even by persons other than the driver
may be illegal. Where such regulations
apply, they must be obeyed.
WARNING
L I G H T G R E E N L E A D A T P O W E R
CONNECTOR IS DESIGNED TO DETECT
P A R K E D S T A T U S A N D M U S T B E
CONNECTED TO THE POWER SUPPLY
SIDE OF THE PARKING BRAKE SWITCH.
IMPROPER CONNECTION OR USE OF
THIS LEAD MAY VIOLATE APPLICABLE
LAW AND MAY RESULT IN SERIOUS
INJURY OR DAMAGE.
CAUTION
• PIONEER does not recommend that
you install or service your display unit
yourself. Installing or servicing the
product may expose you to risk of electric
shock or other hazards.
Refer all installation and servicing of your
display unit to authorized Pioneer service
personnel.
• Secure all wiring with cable clamps or
electrical tape. Do not allow any bare
wiring to remain exposed.
• Do not drill a hole into the engine
compartment to connect the yellow
cable of the display unit to the vehicle
battery. Engine vibration may eventually
cause the insulation to fail at the
point where the wire passes from
the passenger compartment into the
engine compartment. Take extra care in
securing the wire at this point.
• It is extremely dangerous to allow the
microphone lead to become wound
around the steering column or gearstick.
Be sure to install the unit in such a way
that it will not obstruct driving.
• Make sure that cables will not interfere
with moving parts of the vehicle, such
as the gearshift, parking brake or seat
sliding mechanism.
• Do not shorten any cables. If you do,
the protection circuit may fail to work
properly.
WARNING
• Use speakers over 50 W (output value)
and between 4 Ω to 8 Ω (impedance
value). Do not use 1 Ω to 3 Ω speakers
for this unit.
• The black cable is ground. When
installing this unit or power amp (sold
separately), make sure to connect the
ground wire first. Ensure that the ground
wire is properly connected to metal parts
of the car’s body. The ground wire of the
power amp and the one of this unit or
any other device must be connected to
the car separately with different screws. If
the screw for the ground wire loosens or
falls out, it could result in fire, generation
of smoke or malfunction.
Ground wire
Metal parts of car’s body
POWER AMP
Other devices
(Another electronic
device in the car)
Important
• This unit cannot be installed in a vehicle
without ACC (accessory) position on the
ignition switch.
ACC position
No ACC position
• Use this unit with a 12-volt battery and
negative grounding only. Failure to do so
may result in a fire or malfunction.
