Pioneer DV-610, Руководство по эксплуатации

Страница: 56 / 126

09
56
En
Cannot play multi-channel
audio. • Make sure that Audio Output Mode is set to 5.1 Channel
(page 44).
• Check that the
Dolby Digital Out , DTS Out and MPEG Out
settings (page 38) are suitable for your amplifier/receiver — check
the instruction manual that came with your amplifier/receiver.
• DVD-Audio and SACDs do not output multichannel digital audio.
Listen through the player’s analog outputs.
• Check that the settings in the
Speaker Installation screen are
correct (page 49).
• Check the audio options available from the disc menu.
Cannot listen to
high-sampling rate audio
through the digital output. • Make sure that Linear PCM Out is set to Down Sample Off
(page 38).
• As a copy-protection measure, some DVDs do not output 96 kHz
audio. In this case, even if set to
Down Sample Off , the player
automatically outputs the audio at 48 kHz. This is not a malfunction.
Cannot output 192 kHz or
176.4 kHz digital audio.
• The player does not output digital audio at these sampling rates.
The digital output is automatically downsampled.
Cannot output 96 kHz or
88.2 kHz digital audio. • Check that Linear PCM Out is set to Down Sample Off
(page 38).
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automatically
downsampled.
No DTS audio output. • If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set
DTS Out to DTS > PCM
(page 38). If you do not do this, noise will be output when you play a
DTS disc.
• If this unit is connected to a DTS-compatible amplifier or decoder
using a digital audio cable, check the amplifier settings, and that
the cable is properly connected.
Audio mix does not sound
right or sounds incomplete
(for example, inaudible
dialog).
• Make sure that
Audio Output Mode
is set to
2 Channel
if you’ve
connected to the stereo inputs on your amplifier or TV.
The audio recorded on a
Super VCD disc is not output
properly. • If the audio is switched to [2] when playing a Super VCD that
contains only one stereo soundtrack, there may be no sound at all.
Press
AUDIO to change the soundtrack.
Can’t hear effect of Virtual
Surround. • Virtual Surround does not work with SACD or DVD-Audio.
• The Virtual Surround effect is only output through the
AUDIO OUT (5.1ch) FRONT L/R analog audio outputs.
• Make sure that Audio Output Mode is set to 2 Channel
(page 44).
• The effectiveness of Virtual Surround varies with the disc.
Problem Remedy
DV610AV_WY_EN.book 56 ページ ２００８年５月２２日 木曜日 午後１時５９分