DRM-ULV16
23
5
6
7
8
5
6
7
8
C
D
F
A
B
E
7.2.1 CHECK METHOD
With this method, operation checks for the DRM-ULV16 are performed by checking the transfer rate using the DVD-D7563 or
DVD-D7362.
Note:
Use the ASC-29160 or ASC-39160 SCSI card by Adaptec as a host bus adaptor for this checking method.
1. Start up GGS1030 (DiagnoseV), and load the GGV1035 (DVDT-001) in the drive.
2. Select "Data Transfer Rate" (
1
), specify "220000h (HEX: hexadecimal)" to "Address" (
2
), then click on the "Diag" button
(
3
).
3. The notice is displayed to prompt you to check that the drive is set to SCSI-3 mode.
If the "OK" button (
4
) is clicked on after checking, measurement of the data transfer rate starts.
4. Check that the result (
5
) is "Judge: OK".
¶
If the result is NG, check the following:
• Is the SCSI cable properly connected?
• Is the SCSI mode correctly set to SCSI-3?
• Is the termination setting correct?
¶
After checking the above items, turn off the changer,
correct any wrong settings, then retry this check method
from the beginning (power ON).
1
1
2
3
2
4
