DRM-ULV16
17
5
6
7
8
5
6
7
8
C
D
F
A
B
E
7. GENERAL INFORMATION
7.1 INSTALLATION
The DRM-ULV16 is an optional SCSI Board Unit for the DRM-7000 and DRM-3000 Changer System.
How to install this unit in the changer system is described in this section.
The photos and/or illustrations of the DRM-ULV16 and the changer in this manual may differ from those of your product,
but the installation procedures are the same.
The photos and illustrations of the changer system in this manual are those of the DRM-7000, unless otherwise stated.
1
Remove the four screws that secure the side panel.
The side panel is located at the lower right side on the
DRM-7000, and at the right side on the DRM-3000.
2
Remove the side panel.
Removal of the side panel
1
1
Cut the binder to unbind the wires.
2
Disconnect the cables from the connector for the power
(CN101_6P) and the connector for the ID and terminating
switch (CN113_5P) on the MMCB unit.
3
Except for the wires for the connectors disconnected in
Step
2
, bind the wires using the supplied binder as they were.
Note:
Care must be taken not to damage the wires.
MMCB Unit
CN101
CN113
Removal of the rear terminal block
2
1
1
2
3
2
1
1
2
1
Preparations on the side of the changer
Note:
If this unit is used with the DVD-R7783, the firmware version of the changer must be Ver. 1.25 or later.
