Pioneer DRM-3000, Руководство по эксплуатации

Страница: 20 / 228

20
<DRC1184>
En
Label
Guide rails
≠
Installation
Lock pin
Lock release Lock
Handle
Release knob
5. Inserting disc magazines
Any of the following methods may be used to insert discs
into the changer:
1. Insert discs into a normal-type 50-disc magazine and then
insert the magazine into the changer.
2. Insert discs into a 20-disc hyper magazine and then insert
the magazine into the changer.
3. Use the control panel to specify the slot into which a disc
is to be inserted and transport a disc to the specified slot
from the mailslot.
4. Issue some commands from the host computer to open
the mailslot and transport a disc to the specified slot from
the mailslot.
5. Issue some commands from the host computer to move
discs in the loaded hyper magazine to some slots within
the loaded 50-disc magazines.
¶
Hyper magazine is not able to be inserted or removed when
the power to the changer is turned off.
¶
Methods 3 through 5 may be used after the changer is
ready for operation. When inserting discs in these
methods, always be sure to insert empty disc magazines
first.
Also note that methods 3 through 5 are used when
inserting locked-type 50-disc magazines. (See System
administrator mode: Mailslot submode on p. 34 for further
information.)
¶
Whether or not it is possible to use methods 4 and 5
depends on the function of changer control software being
used, and you should check the manual which comes with
the software to check if it supports these methods to insert
discs.
1. Insert discs into a normal-type 50-disc magazine and
insert the magazine into the changer.
1
Turn the release knob to the vertical direction to unlock.
2
Insert discs.
3
Turn the release knob to the horizontal direction to lock
the discs into place.
NOTES:
¶
Insert with label facing upward.
¶
Insert discs horizontally. Otherwise it may result in
damage to the discs.
¶
Be careful not to scratch the reflective signal recording
surface.
¶
Do not turn a disc magazine upside down while the
lock is disengaged. Otherwise it may result in discs
falling out of the magazine.
4
Insert magazine into changer.
Holding the handle of the disc magazine, insert the disc
magazine into the changer following the changer guide
rails until it runs against the stopper.
And turn the handle to the left with pushing the magazine
in so that the lock pin on the left of the magazine slides
into the corresponding hole along the side of the changer.
Shown above is the insertion to the front magazine bay.
Though the insertion to the rear magazine bay is almost
same but note that the proper installation position is in the
place where it is very secluded.
To remove a disc magazine from the changer, pull the
handle towards you and pull the magazine from the
changer.
Hole
Example: Loading magazine in front bay