Symptom
Cause
Action
No sounds are heard.
Optical cables are incorrectly con-
nected.
Connect the cables correctly. (Page 4)
DVD player setting
Symptom
Cause
Action
No sounds come from the DVD
player only.
Optical cables are incorrectly con-
nected.
Connect the cables correctly.
The DVD player is not properly set
for output.
Make the correct output setting. (See the
manual for the DVD player.)
Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.
Message
Cause
Action
Error check MIC
Microphone is not connected.
Plug the supplied microphone securely into
the jack.
Error check front SP
,
Error
check FL SP
,
Error check FR SP
,
Error check center SP
,
Error
check RL SP
,
Error check RR SP
,
Error check subwoofer
The microphone cannot pick up the
measuring tone of a speaker.
!
Confirm that the speakers are connected
correctly.
!
Correct the input level setting of the power
amp connected to the speakers.
!
Set the microphone correctly.
Error check noise
The surrounding noise level is too
high.
!
Stop your car in a place that is as quiet as
possible, and switch off the engine, air condi-
tioner or heater.
!
Set the microphone correctly.
Additional Information
En
22
Appendix