5 Touch
to turn the panorama control
on.
#
To turn the panorama control off, touch
.
6 Touch
and then touch
or
to ad-
just front/surround speaker balance.
Each time you touch
or
it moves the
sound towards the front or the surrounds.
+3
3
is displayed as the front/surround
speaker balance moves from front to sur-
rounds.
7 Touch
and then touch
or
to ad-
just the center image.
Each time you touch
or
it gradually
spreads the center channel sound into the
front left and right speakers over a range
0
7
.
3
is the default and it
s recommended for
most recordings.
0
places all center sound in
the center speaker.
7
places all center sound
equally in the left/right speakers.
Setting the speaker setting
You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to
LARGE
(large)
if the speaker is capable of reproducing
sounds of about 100 Hz or below. Otherwise
select
SMALL
(small).
!
Low frequency range is not output if the
subwoofer is set to
OFF
and the front and
rear speakers set to
SMALL
or
OFF
.
!
It is imperative that non-installed speakers
be set to
OFF
.
!
Set the front or rear speaker to
LARGE
if
the speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch SPEAKER SETTING.
3 Touch
or
to select the speaker to
be adjusted.
Each time you touch
or
selects the
speaker in the following order:
FRONT
(front speakers)
CENTER
(center
speaker)
REAR
(rear speakers)
SUB WOOFER
(subwoofer)
PHASE
(sub-
woofer setting)
#
You can switch to
PHASE
only when the sub-
woofer has been set to
ON
.
4 Touch
or
to select the correct size
for the selected speaker.
Each time you touch
or
selects the size
in the following order:
OFF
(off)
SMALL
(small)
LARGE
(large)
#
You cannot select
OFF
, when
FRONT
(front
speakers) have been selected.
#
You can select
ON
or
OFF
, when
SUB WOOFER
(subwoofer) has been selected.
#
You can switch
REVERSE
(reverse phase) or
NORMAL
(normal phase), when
PHASE
(subwoo-
fer setting) has been selected.
Correcting the subwoofer
s phase
If trying to boost the bass output of the sub-
woofer doesn
t do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer
s output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch SPEAKER SETTING.
Digital Signal Processor
En
12
Section
03
