2 Touch SP Lev.
3 Touch
or
to select the speaker to
be adjusted.
Each time you touch
or
selects the
speaker in the following order:
FRONT-L
(front speaker left)
CENTER
(center
speaker)
FRONT-R
(front speaker right)
REAR-R
(rear speaker right)
REAR-L
(rear
speaker left)
SUB WOOFER
(subwoofer)
#
You cannot select speakers whose size is set
at
OFF
.
4 Touch
or
to adjust the speaker
output level.
Each time you touch
or
increases or de-
creases the speaker output level.
+10
10
is
displayed as the level is increased or de-
creased.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
TEST TONE
. Both provide the same results.
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch TEST TONE.
3 Touch START to start the test tone out-
put.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
FRONT-L
(front speaker left)
CENTER
(center
speaker)
FRONT-R
(front speaker right)
REAR-R
(rear speaker right)
REAR-L
(rear
speaker left)
SUB WOOFER
(subwoofer)
Check each speaker output level. If no adjust-
ments are needed, perform step 5 to stop the
test tone.
#
You can also start the test tone output by mov-
ing the joystick up.
#
The settings do not appear for speakers
whose size is set
OFF
.
4 Touch
or
to adjust the speaker
output level.
Each time you touch
or
increases or de-
creases the speaker output level.
+10
10
is
displayed as the level is increased or de-
creased.
#
The test tone rotates to the next speaker after
about two seconds from the last operation.
5 Touch STOP to stop the test tone out-
put.
#
You can also stop the test tone output by mov-
ing the joystick down.
Notes
!
If needed, select speakers and adjust their
ab-
solute
output levels. (Refer to
Adjusting the
speaker output levels
on the previous page.)
!
To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at
SP Lev
. Both provide the same re-
sults.
Using the time alignment
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
Digital Signal Processor
En
14
Section
03