#
When the rear output setting is
Rear SP :S/W
,
you cannot change the subwoofer controller.
3 Push Multi-Control left or right to
switch the subwoofer output or nonfading
output (full-range RCA output).
Each pushing
Multi-Control
left or right will
switch between
Preout :S/W
and
Preout :FULL
and that status will be displayed.
Notes
!
Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to
Using nonfading output
on page 52)
or subwoofer output (refer to
Using subwoofer
output
on page 51) in the audio menu on.
!
If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
!
Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
!
The sound is turned off or attenuated,
MUTE
or
ATT
is displayed and no audio ad-
justment is possible.
!
Sound from this system returns to normal
when the muting or attenuation is can-
celled.
1 Use Multi-Control to select Mute.
Mute
appears in the display.
2 Press Multi-Control to switch the tele-
phone muting/attenuation.
Pressing
Multi-Control
will switch between
TEL ATT
(attenuation) and
TEL mute
(muting)
and that status will be displayed.
Switching the feature demo
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
1 Use Multi-Control to select
Demonstration.
Demonstration
appears in the display.
2 Press Multi-Control to turn the feature
demo on.
ON
appears in the display.
#
To turn the feature demo off, press
Multi-Control
again.
Notes
!
Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.
!
You can also turn on or off feature demo by
pressing button
6
while this unit is turned off.
For more details, see
Feature demo
on page
10.
Switching the reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds.
1 Use Multi-Control to select
Reverse mode.
Reverse mode
appears in the display.
Initial Settings
En
56
Section
12