En
37
English
Español
Deutsch
F
rançais
Italiano
Nederlands
08
Section
Initial Settings
Selecting the brightness
You can select the display brightness. Initially
this mode is set to 12.
1 Press
FUNCTION
to select
BRIGHT
.
Press
FUNCTION
repeatedly until
Brightness
appears in the display.
2 Select the desired brightness with
2
/
3
.
• The display shows
0
–
15
.
Setting the rear output and sub-
woofer controller
This product’s rear output (rear speaker leads
output) can be used for full-range speaker (
Rear
SP:FULL
) or subwoofer (
Rear SP:S.W
) connec-
tion. If you switch rear output setting to the
Rear
SP:S.W
, you can connect a rear speaker lead
directly to a subwoofer without using an auxil-
iary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL
).
When rear output are connected to full range
speakers (when
Rear SP:FULL
is selected), you
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass
filter, phase) built-in
S.W Control:INT
or the
auxiliary
S.W Control:EXT
.
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 33) or subwoofer output
(refer to page 32) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
1 Press
FUNCTION
to select
SW
.
Press
FUNCTION
repeatedly until
Rear SP
appears in the display.
2 Change the rear output setting with
5
/
∞
.
Pressing
5
/
∞
will switch between
Rear SP
:FULL
(full-range speaker) and
Rear SP :S.W
(subwoofer) and that status will be displayed.
Notes
• When no subwoofer is connected to the rear
output, select
Rear SP:FULL
.
• When a subwoofer is connected to the rear
output, set for subwoofer
Rear SP:S.W
.
• When the rear output setting is
Rear SP:S.W
,
you cannot change the subwoofer controller.
3 Change the subwoofer controller with
2
/
3
.
Pressing
2
/
3
will switch between
S.W Control
:INT
and
S.W Control :EXT
and that status will
be displayed.