Setting the rear output and
subwoofer controller
This unit
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
R-SP :FUL
) or subwoofer
(
R-SP :S/W
) connection. If you switch the rear
output setting to
R-SP :S/W
, you can connect
a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
R-SP :FUL
). When rear output is
connected to full range speakers (when
R-SP :FUL
is selected), you can connect other
full range speakers (
P/O :FUL
) or a subwoofer
(
P/O :S/W
) to the RCA rear output.
1 Press FUNCTION to select R-SP.
Press
FUNCTION
repeatedly until
R-SP
ap-
pears in the display.
2 Press
a
or
b
to switch the rear output
setting.
Pressing
a
or
b
will switch between
R-SP :FUL
(full-range speaker) and
R-SP :S/W
(subwoofer) and that status will be displayed.
#
When no subwoofer is connected to the rear
output, select
R-SP :FUL
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
R-SP :S/W
.
#
When the rear output setting is
R-SP :S/W
,
you cannot operate the following procedure.
3 Press
c
or
d
to switch the subwoofer
output or rear output.
Pressing
c
or
d
will switch between
P/O :S/W
and
P/O :FUL
and that status will be displayed.
Notes
!
Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to
Using subwoofer output
on page
32).
!
If you change this setting, subwoofer output
in the audio menu return to the factory
settings.
Initial Settings
En
36
Section
09
