Pioneer DEH-600BT, Руководство по эксплуатации

Страница: 38 / 51

4 Push MULTI-CONTROL left or right to
select a desired level.
Each time
MULTI-CONTROL
is pushed left or
right, level is selected in the following order:
LOW (low)
—
MID (mid)
—
HIGH (high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
Also, phase can be selected between normal
and reverse.
1 Display the audio menu.
Refer to Introduction of audio adjustments on
page 36.
2 Use MULTI-CONTROL to select SUB W1.
3 Press MULTI-CONTROL to turn subwoo-
fer output on.
NORMAL
appears in the display. Subwoofer
output is now on.
#
To turn subwoofer output off, press
MULTI-CONTROL again.
4 Push MULTI-CONTROL left or right to
select the phase of subwoofer output.
Push MULTI-CONTROL left to select reverse
phase and
REV
appears in the display. Push
MULTI-CONTROL
right to select normal phase
and
NORMAL
appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
!
When the subwoofer output is on, you can
select
SUB W2 .
1 Display the audio menu.
Refer to Introduction of audio adjustments on
page 36.
2 Use MULTI-CONTROL to select SUB W2.
3 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time
MULTI-CONTROL
is pushed left or
right, cut-off frequencies are selected in the
following order:
50
—
63
—
80
—
100
—
125
4 Push MULTI-CONTROL up or down to
adjust the output level of the subwoofer.
Each time
MULTI-CONTROL
is pushed up or
down, subwoofer level increases or decreases.
+6 to
–
24 is displayed as the level is increased
or decreased.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
1 Display the audio menu.
Refer to Introduction of audio adjustments on
page 36.
2 Use MULTI-CONTROL to select HPF.
3 Press MULTI-CONTROL to turn high
pass filter on.
80HZ
appears in the display. High pass filter is
now on.
#
If the high pass filter has been previously ad-
justed, the frequency of that previously selected
will be displayed instead of
80HZ
.
#
To turn high pass filter off, press
MULTI-CONTROL again.
4 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50HZ
—
63HZ
—
80HZ
—
100HZ
—
125HZ
Audio Adjustments
En
38
Section
03