Important
!
This unit can not be installed in a vehicle that
does not have an ACC (accessory) position on
the ignition switch.
ACC
ON
S
T
A
R
T
O
FF
ON
S
T
A
R
T
O
FF
ACC posi-
tion
No ACC po-
sition
!
Use this unit in other than the following condi-
tions could result in fire or malfunction.
—
Vehicles with a 12-volt battery and negative
grounding.
!
To prevent short-circuit, overheating or mal-
function, be sure to follow the directions
below.
—
Disconnect the negative terminal of the
battery before installation.
—
Secure the wiring with cable clamps or ad-
hesive tape. To protect the wiring, wrap ad-
hesive tape around them where they lie
against metal parts.
—
Place all cables away from moving parts,
such as gear shift and seat rails.
—
Place all cables away from hot places,
such as near the heater outlet.
—
Do not pass the yellow cable through a
hole into the engine compartment to con-
nect to a battery.
—
Cover any disconnected cable connectors
with insulating tape.
—
Do not shorten any cables.
—
Never cut the insulation of the power cable
of this unit in order to share the power to
other equipment. Current capacity of the
cable is limited.
—
Use a fuse of the rating prescribed.
!
Refer to the owner
’
s manual for details on
connecting the power amp and other units,
then make connections correctly.
!
IP-BUS connectors are color-coded. Be sure
to connect connectors of the same color.
Cord function may differ according to the pro-
duct, even if cord color is the same. When con-
necting this system, be sure to check all
manuals and connect cords correctly.
Connections
En
34
Section
06
