if the speaker is capable of reproducing
sounds of about 100 Hz or below. Otherwise
select
SMALL
(small).
!
Low frequency range is not output if the
subwoofer is set to
OFF
and the front and
rear speakers set to
SMALL
or
OFF
.
!
It is imperative that non-installed speakers
be set to
OFF
.
!
Set the front or rear speaker to
LARGE
if
the speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1 Press
p
and hold until SP Set appears
in the display.
2 Press
m
or
n
to select the speaker
to be adjusted.
Each press of
m
or
n
selects the speaker
in the following order:
Front speakers
Center speaker
Rear speak-
ers
Subwoofer
S.W
(subwoofer setting)
#
You can switch to
S.W
only when the subwoo-
fer has been set to
ON
.
3 Press
r
or
q
to select the correct size
for the selected speaker.
Each press of
r
or
q
selects the size in the
following order:
LARGE
(large)
SMALL
(small)
OFF
(off)
#
You cannot select
OFF
, when
FRONT
(front
speakers) have been selected.
#
You can select
ON
or
OFF
, when
SUB.W
(sub-
woofer) has been selected.
#
You can switch
Rev.
(reverse phase) or
Normal
(normal phase), when
S.W
(subwoofer
setting) has been selected.
4 Press BAND to return to the playback
display.
Correcting the subwoofer
s phase
If trying to boost the bass output of the sub-
woofer doesn
t do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer
s output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Press
p
and hold until SP Set appears
in the display.
2 Press
m
or
n
to select the subwoo-
fer.
Each press of
m
or
n
selects the speaker
in the following order:
Front speakers
Center speaker
Rear speak-
ers
Subwoofer
S.W
(subwoofer setting)
3 Press
r
to turn the subwoofer output
on.
4 Press
n
to select S.W (subwoofer set-
ting).
5 Press
q
or
r
to select the subwoofer
output phase.
Press
r
to select
Normal
(normal phase).
Press
q
to select
Rev.
(reverse phase).
6 Press BAND to return to the playback
display.
Note
When playing a 2-channel mono source with Pro
Logic turned on, there may be occasions when
the following will occur:
!
No audio is output if the center speaker set-
ting is
SMALL
or
LARGE
and no center speak-
er is installed.
!
Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL
or
LARGE
.
Digital Signal Processor
En
23
English
Section
07
