10
En
Do not cover this area.
•
The semiconductor laser will be damaged
if it overheats, so don’t install this product
anywhere hot- for instance, near a heater
outlet.
1
Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw
holes are aligned with the screw holes
of the bracket, and tighten the screws at
three locations on each side.
Use either the truss head screws or flush
surface screws, depending on the shape
of the bracket’s screw holes.
Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
Dashboard or console
Truss head screw or flush surface
screw
Be sure to use the screws supplied
with this product.
CAUTION
Do not cut the GPS antenna lead to
shorten it or use an extension to make it
longer. Altering the antenna cable could
result in a short circuit or malfunction and
permanent damage to this product.
•
The antenna should be installed on a
level surface where radio waves will be
blocked as little as possible. Radio waves
cannot be received by the antenna if
reception from the satellite is blocked.
Installation using the
screw holes on the side
of this product
Installing the GPS
antenna
Installation notes
Dashboard
Rear shelf
•
When installing the GPS antenna inside
the vehicle, be sure to use the metal
sheet provided with your system. If this is
not used, the reception sensitivity will be
poor.
•
Do not cut the accessory metal sheet.
This would reduce the sensitivity of the
GPS antenna.
•
Take care not to pull the antenna lead
when removing the GPS antenna. The
lead may become detached.
•
Do not paint the GPS antenna, as this
may affect its performance.
