Pioneer AVH-P3150DVD, Руководство по эксплуатации

Страница: 82 / 112

Black plate (82,1)
Note
When playing a 2-channel mono source with
Dolby Pro Logic II turned on, there may be occa-
sions when the following will occur:
!
No audio is outputted if the center speaker
setting is
Small
or
Large
and no center speak-
er is installed.
!
Audio is heard only over the center speaker if
installed and the center speaker setting is
Small
or
Large
.
Adjusting the speaker output
levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1 Touch Speaker Level.
2 Touch
a
or
b
to select the speaker to
be adjusted.
Each time you touch
a
or
b
selects the speak-
er in the following order:
Front-L
(front speaker left)
—
Center
(center
speaker)
—
Front-R
(front speaker right)
—
Rear-R
(rear speaker right)
—
Rear-L
(rear
speaker left)
—
Subwoofer
(subwoofer)
#
You cannot select speakers whose size is set
to Off . (Refer to Setting the speaker setting on the
previous page.)
3 Touch
c
or
d
to adjust the speaker out-
put level.
Each time you touch
c
or
d
it increases or de-
creases the equalizer level. +10 to
–
10 is dis-
played as the level is increased or decreased.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
Test Tone . Both provide the same results.
Selecting a cross-over frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to
Small , you can select a
frequency, under which sounds are repro-
duced through a
Large speaker or subwoofer.
1 Touch Cross Over.
2 Touch
a
or
b
to select the speaker to
be adjusted.
Each time you touch
a
or
b
selects the speak-
er in the following order:
Front (front speakers)
—
Center (center speak-
er)
—
Rear
(rear speakers)
—
Subwoofer
(sub-
woofer)
3 Touch
c
or
d
to select cross-over fre-
quency.
Each time you touch
c
or
d
selects cross-over
frequencies in the following order:
63Hz
—
80Hz
—
100Hz
—
125Hz
—
160Hz
—
200Hz
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofer
’
s L.P.F. (low-pass
filter) and that of the Small speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to
Off and other
speakers are set to Large or Off .
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Touch Test Tone.
<
CRB2868-A/N
>82
Available accessories
En
82
Section
19