Pioneer 1200, Руководство по техническому обслуживанию

Страница: 165 / 300

TROUBLESHOOTING AND ELECTRICAL SYSTEM: FE400 ENGINE Test Procedures
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual Page 11-45
11
4. Allow the engine to idle for at least six minutes (the meter records in six-minute increments). See fol-
lowing DANGER.
∆
DANGER
• Do not operate gasoline vehicle in an enclosed area without proper ventilation. The engine
produces carbon monoxide, which is an odorless, deadly poison.
5. If the reading does not change after six minutes, then replace the fuel gauge/hour meter.
TEST PROCEDURE 28 – LIGHT SWITCH
See General Warning, Section 1, Page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed (Figure 11-1, Page 11-5). See WARNING "To avoid unin-
tentionally starting..." in General Warning, Section 1, Page 1-2.
3. Remove the center dash assembly. See Key Switch Removal, Section 12, Page 12-14.
4. Use a multimeter set on 20 volts DC with alligator clips on the meter probes. Connect the red (+) probe
to the light switch terminal with the blue wire connected to it (Figure 11-56, Page 11-45).
∆
CAUTION
• Before connecting battery cables, make sure none of the electrical components touch the
front body trim or other parts of the vehicle frame. Place a dry towel between the body trim
and the center dash to prevent an electrical short.
5. Connect the battery cables, positive (+) cable first, and tighten terminals to 20 ft-lb (27 N·m). Coat ter-
minals with Battery Terminal Protector Spray (CCI P/N 1014305).
6. Connect the black (–) probe of the multimeter to the negative (–) post of the battery.
Figure 11-56 Light Switch Test
LIGHT
SWITCH
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
Ω
Ω
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM
200nA
MAX
1000 ---
750V
FUSED