ELECTRICAL COMPONENTS: FE400 ENGINE
Fuse
Page 12-16
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
12
2. Disconnect the battery cables as instructed (Figure 12-1, Page 12-1). See WARNING "To avoid unin-
tentionally starting..." in General Warning, Section 1, Page 1-2.
3. Remove electrical component box cover.
4. Remove the fuse from the fuse block.
Fuse Installation
1. Install the fuse. See following WARNING.
∆
WARNING
• If a fuse is blown, determine the cause of the failure and make necessary repairs before
installing a new fuse. Use the appropriately rated fuse; if a fuse with a higher amp rating is
used, damage to the vehicle electrical system may occur.
2. Install the snap-on electrical box cover by firmly pressing down on all corners and install the screw and
tighten to 18 in-lb (2 N·m).
3. Connect the battery cables, positive (+) cable first, and tighten the terminals to 20 ft-lb (27.1 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
Figure 12-20 Center Dash Panel Removal
A
B
Содержание 1200
