13
: Press the button to enter the acquire function menu,
under which you could set the acquisition mode, sampling mode
and dot inserting mode.
: Press the button to enter the file save and recall function
menu. There are four types of file to be saved which are
respectively setups, waveforms, picture and CSV, and additionally
the factory setup are supported.
: Press the button to enter the measurement function menu.
There are three measure types: voltage, time and delay. Each kind
of them contains many measurement parameters, you could press
any of them to display the corresponding value.
: Press the button to enter the display function menu,
under which you could set waveform display type, persist time,
waveform brightness, display format, menu display and so on.
: Press the button to enter the utility function menu, under
which you could set the corresponding function of the system, some
parameters like Sound, Language, Interface and so on. In
addition,
some advanced functions are also supported such as Self
Calibration, Firmware Update, Pass/Fail test.
○
5
Default Setup.
: Press the button to restore the oscilloscope to its default
settings. The default voltage scale and time base are respectively
1v/div and 500us.
○
6
Help.
: Press the button to enable HELP function, and then press
down any menu to display corresponding help information. To
display the submenus help information of the current menu, firstly
you should open the current menu, and then press down the
“HELP” button, the last step is to select any submenu you want.
Содержание DS-1010P
