Pinnacle Technology PP7MX, Руководство по управлению

Страница: 8 / 33

6
Details:
●
If the character horizontal direction magnification ratio is more than 2, the right space amount is also
enlarged accordingly.
●
This command does not affect Chinese characters.
●
Right space amounts can be set independently for both the standard and page modes.
●
The basic calculated pitch is set by GSP (Set basic calculated pitch). Also, after setting the right space
amount, it is not affected even if the basic calculated pitch is changed.
●
If the calculation results in fractions, the pitch is corrected to a minimal mechanical pitch and the rest is
discarded.
●
In standard mode, the basic calculated pitch (x) for the horizontal direction is used.
●
In page mode, the basic calculated pitch that is used according to the starting point varies.
a. When the starting point is specified to be upper left or lower right by the ESC T command (Character print
direction selection in page mode), the basic calculated pitch (x) for the horizontal direction is used.
b. When the starting point is specified to be upper right or lower left by the ESC T command (Character print
direction selection in page mode), the basic calculated pitch (y) for the horizontal direction is used.
●
The maximum value that can be set for the right space amount is approximately 35.983 mm (or 255/180
inch). Specifications that exceed the maximum value are rounded off to that value.
(9)

ESC
！
Select print modes
Format: ASC
Ⅱ
ESC ! n
Decimal 27 33 n
Hex 1B 21 n
Range 0
≤
n
≤
255
Initial Value n=0
Function Select print mode(s) using n as follows.
Bit Off/On 1/0 Hex Decimal Functions
0 Off 0 00 0 Character font A(12
×
24) selected
1
，
2 Off --- --- Reserved
3
Off 0 00 0 Emphasized mode not selected.
On 1 08 8 Emphasized mode selected.
4
Off 0 00 0 Double-height mode not selected.
On 1 10 16 Double-height mode selected.
5
Off 0 00 0 Double-width mode not selected.
On 1 20 32 Double-width mode selected.
6 Off --- --- Reserved
7
Off 0 00 0 Underline mode not selected.
On 1 80 128 Underline mode selected.
Details:
●
Quadruple-size characters are printed by specifying both double-tall (bit4=1) and double-wide (bit 5=1)
modes.
●
An underline is applied to the entire character width, including the ESC SP (character right space amount).
However, underlines are not applied to portions that have been skipped using HT (horizontal tab) or ESC V
(character 90 degree rotation).
●
The thickness of the underline is set by ESC - (specify/cancel underlines) regardless of the character.
●
The base line for characters is the same when there are characters having different vertical direction ratios in