Pinnacle Technology PP7MX, Руководство по управлению

Страница: 16 / 33

14
Reference: CAN, ESC L, ESC T, GSP
(23)

ESC \ nL nH Specify relative position
Format: ASC
Ⅱ
ESC FF
Decimal 27 92
Hex 1B 5C
Range:
0 ≤ nL ≤ 255, 0 ≤ nH ≤ 255
Description:
Specifies the next print starting position with a relative position based on the current position. This sets the
position from the current position to [(nL + nH x 256) x basic calculated pitch] for the next print starting
position.
Note:
●
Specifications exceeding the print range are ignored.
●
If the right direction of the current position is specified for the character direction, specify a positive number;
if the left direction is specified, a negative number is used.
●
Negative numbers is represented by the complement of 65536. For example, when moving in the left
direction n pitches, use: nL + nH × 256 = 65536-N
●
The basic calculated pitch is set by GSP (basic calculated pitch setting).
●
If there are fractions in the result, correct to the minimum mechanical pitch and discard.
●
Use the basic calculated pitch (x) for the horizontal direction in standard mode.
●
The following operations occur according to the starting point in page mode.
a. If the starting point is set to upper left or lower right by the ESC T (Select character print direction in page
mode) command, specify the relative position of the vertical direction in the paper feed. Use the basic
calculated pitch (x) for the horizontal direction at this time.
b. If the starting point is set to upper right or lower left by the ESC T (Select character print direction in page
mode) command, move the print position in the paper feed direction. Use the basic calculated pitch (y) for
the horizontal direction at this time.
Reference: ESC $, GS P
(24)

ESC a Position alignment
Format: ASCII ESC a n
Hex. 1B 61 n
Decimal 27 97 n
Range: 0 ≤ n ≤ 2, 48 ≤ n ≤ 50
Default Value : n = 0
Description : Aligns all print data in one line to a specified position.
N Position
0, 48 Left alignment
1, 49 Center
2, 50 Right alignment
Notes:
●
This command is effective only when input at the top of the line when standard mode is being used.
●
This command has no affect in page mode. In page mode, this command is only effective for the setting.
●
Specifies the alignment position in the printing region that has been set.