Pilz PNOZ m ES Profinet, Руководство по эксплуатации

Страница: 18 / 23

Operation
Operating Manual PNOZ m ES Profinet
1003386­EN­02
18
7 Operation
7.1 Messages
When the supply voltage is switched on, the PNOZmulti safety system copies the configur­
ation from the chip card.
The LEDs “POWER”, “DIAG”, “FAULT”, “IFAULT” and “OFAULT” will light up on the base
unit.
The expansion module PNOZ m ES Profinet is configured and started automatically. The
LEDs "RUN" and "ERR" display the status of the PNOZ m ES Profinet at the PROFINET.
If the expansion module PNOZ m ES Profinet does not receive a configuration from the
base unit for a period of 30 s, the expansion module PNOZ m ES Profinet connects to the
IO controller and "RUN" status is displayed on PROFINET. The error message "No Con­
nection with Base Module" is sent to the IO controller.
Legend:
LED on
LED flashes
LED off
LED Meaning
Power Green Supply voltage is present
Supply voltage is not present
Run Green The connection to the IO controller is established, the IO controller is in
RUN condition
green, 1x The connection to the IO controller is established, the IO controller is in
STOP condition
Green Device identification (LED "Diag" also flashes green)
No connection to IO controller
Diag Red Diagnostic data available (maintenance required or error)
Green Device identification (LED "Run" also flashes green)
Red No device name assigned