2
Pin hinge(24x24mm)
Make sure hinges are
mounted in the same line.
Apply instant type CA glue to aileron and pin hinge.
Epoxy the control horns to the slots in the rudder.
Lock the linkage to the control horn with screws and nuts
as below.
rudder
1mm
Trailing
edge
Make sure they are in
the right position while
installing.
Keep some space about 1mm width between the rudder and
tail edge.
Epoxy the rudder to the vertical fin.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Rod (2x300mm)
Screw (2x10mm)
Nut (2mm)
Washer (2x6mm)
Linkage Stopper
Washer (2mm)
Washer (2mm)
Nut (2mm)
Set screw (3x4mm)
Washer (2mm)
Set screw (3x4mm)
1
1
1
1
Install the servo of rudder.
6
32
31
30
27
29
28
Elevator
Rudder
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
The standard sketch map when the kit install completion.
A
A ’
A = A ’
B = B ’
B
B ’
Collar (5mm)
2
1
Wheel (65 mm)
1
Steering fullarm (50x6mm)
2
Washer(3x6mm)
2
Screw (3x10mm)
1
Aluminum shaft(5x30mm)
Steering fullarm (50x6mm)
Washer(3x6mm)
Screw (3x10mm)
Aluminum shaft(5x30mm)
collar (5mm)
collar (5mm)
Wheel (65 mm)
Aluminum shaft
Screw (3x10mm)
Screw (3x10mm)
Washer(3x6mm)
Washer(3x6mm)
Steering fullarm (50x6mm)
Assemble the nose wheel.
3mm
4
TP Screw (3x20mm)
TP Screw (3x20mm)
Install the nose landing gear to appropriate position in
the fuselage.
2
Washer(2x6mm)
Screw (2x10mm)
2
Collar (5mm)
2
1
2
Wheel (65mm)
2
4
Clevis
2
Copper joiner
2
Aluminum tube
1
2
1
Steel wire (0.5x900mm)
TP Screw (3x20mm)
2
2
Nut (2mm )
Accessory list for the coming installation steps.
Assemble the rudder servo in the fuselage.
Epoxy the fairing parts to the slots in the fuselage.
7
36
33
35
34
37
