Apply instant type AB glue to the control horn and the slots in
the aileron, insert the control horn to the slots as illustration.
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A = A '
B = B '
The standard sketch map when the kit install completion.
A
A=A’
B=B’
A’
B
B’
Cut away the film on the position for the air retract
landing and epoxy the wheel house to relevant position.
Retracts strut
LockNut(4mm)
Wooden Block
Note:rubber wheels oleo struts
and retracts are optional.
Assemble the gear doors and the wheels to the retracts.
2
Screw (4x35mm)
1
Gear door
2
Wheel (75mm)
2
LockNut (4mm)
2
PVC
1
Reinforcement plate
4
Wooden Block(25x15x13mm)
1
PVC
Main wing joiner
1
TP Screw(3x20mm)
8
2
Washer(4x8mm)
Accessory list for the coming installation steps.
Cut off the surplus PVC part carefully along the shaded
line
6
7
9
8
2
10
Fix the motor mount box to the fuselage with screws.
Washer (4x8mm)
Screw (4x20mm)
Washer (4x8mm)
Screw (4x20mm)
Assemble the motor as below.
Epoxy the interior cockpit to the canopy.
Assemble the canopy to the fuselage with screws.
Assemble the Li-Po battery to appropriate position in
the fuselage.
Li-Pox4 (2000mAh)
2
Washer (3x6mm)
2
Screw (3x16mm)
5
TP Screw (2.3x8mm)
Ply (15x15x3mm)
5
2
Exhaust
2
Washer (3x6mm)
2
Screw (3x16mm)
Accessory list for the coming installation steps.
11
59
55
56
57
58
