Appendix
Guideline Installation PikoLoad
Page 30 / 32
Version 1
5.2.2
PikoLoad CAN 2 Pin Assignment
1
6
5
10
Figure 29: PikoLoad CAN 2 Pin Assignment
Pin 1
GND
Pin 2
Reserved
Pin 3
CAN high
Pin 4
CAN low
Pin 5
Ground (Out)
Clamp 31
Pin 6
12 VDC (Out, optional)
Pin 7
Clamp 15R (Out, optional)
Pin 8
Ignition (24V, Out, max. 100mA)
Clamp 15
Pin 9
Reserved
Pin 10
24 VDC (Out, max. 5A)
Clamp 30
Note:
Ignition is 24 VDC !
Note: This CAN has a 120 Ohm terminating resistor!
The power supply of the PikoTest is via the green connector (CAN 1)
The power supply on CAN 2 is output only!
All FMS data (if available) are routed to the CAN 2 interface of PikoLoad.
CAN 2
PikoLoad
Power supply for bord computer
Ignition
FMS-Data (CAN) if available
Figure 30: PikoLoad CAN 2 connection
