PIKO SmartMeasure Car, Инструкция по эксплуатации

Страница: 34 / 96

34
3.2.2 Touch sensible areas
Right and left of the display area are areas that react to an approaching finger. Put your fingertip
onto one of the areas marked in the picture and remain there for 0,5 seconds. Then the display will
switch through the different measurement screens or functions - see point 2.3 - without using any
pressure. Whether another screen is available maybe be seen by the small arrows at the lower
screen area.
3.3 The „mice piano“ – the cars side with pushbuttons and LEDs (opposite side of display)
Behind the other door of the PIKO SmartMeasure Car you can find the so called “mice piano”.
Here you will find four LEDs, four pushbuttons and an USB port:
3.3.1 The meaning of the LEDs – from left to right:
1. The red LED
a) Will blink together with the yellow LED when the car is booting / starting up, or when
firmware is
b) Is blinking permanently when there is a failure
c) Is blinking permanetly when the „POWER“-button is pressed an the car can be switched off
2. The yellow LED
a) Blinks together with the red LED when car is booting / starting up
b) Is blinking when data are transferred via USB
c) Is blinking permanently when „test run“ is active
3. The green LED
a) Is permanent-on when car is active
b) Will blink when battery is low
4. The blue LED
a) Is permanent-on when WiFi is active
b) Is off when WiFi is off
2017-09-21 Bed. Anleitung Messwagen_55050-90-7001.indd 34 21.09.17 16:56