PIKO 37309, Инструкция по эксплуатации

Страница: 22 / 24

22
Servo control
The sound decoder allows direct control
of four servo motors via the servo slots
of the carrier board. Here the slots
Servo1 (top) and Servo 2 (bottom) are
occupied. Servo 1 controls the single-
arm pantograph at the front and servo
2 controls the scissor pantograph at the
rear. Please refer to the CV table for the
setting options of the stop positions
and the respective travel speed. The
assignment to the function keys is done
exclusively via the extended function
mapping.
Sound settings
The overall sound volume of the built-in
sound module can be changed as desi-
red via CV902.
NOTE: To record a PIKO sound on the
sound decoder, you need the test and
programming device PIKO SmartPro-
grammer (#56415) and (optional) the
PIKO SmartTester (#56416).
For all further information about the
sound part of the PIKO SmartDecoder
XP 5.1 Sound G and the available set-
ting options, please refer to the detailed
operating instructions. of the sound
module #36192, which you can find
in the PIKO Webshop at this article for
download.
Energy storage
The energy storage built on the deco-
der can be switched on or off via CV
programming. The backup time can be
set in 500ms steps up to 8 seconds.
If CV251 = 128 (Bit7 = 1) is set, the
energy storage is switched on and the
backup time is 500ms. Bits 0 - 3 can
now be used to increase the back-up
time in the above-mentioned increments
up to 8 seconds.
Reset to factory setting (Reset)
To reset the sound decoder to factory
settings, please program CV8 = 8.
Programming
The basis of all setting possibilities
of the decoder are the configuration
variables (CVs). The decoder can be pro-
grammed with the PIKO G digital com-
mand station with Navigator or other
DCC command stations, as well as with
Motorola command stations.
For more information about the pro-
gramming possibilities, please refer to
the detailed operating instructions.
Function assignments
F0 Light F9 Coupling F18 Train Brakes
F1 Motor F10 Sanding F19 Clickety-Clack
F2 Short Whistle Blast F11 Volume Regulator F20 Curve Squeal
F3 Long Whistle Blast F12 Tunnel mode
F4 Interior Lighting * F13 Brake Squeal Deactivated
F5 Preheater F14 Passenger Car Window
F6 Conducter‘s Whistle F15 Door
F7 Switching Gear F16 Hand Brakes
F8 Air Valve Release F17 Emergency Brake
* version-dependent