5
Sets the length of the delay line. Turning the Time knob overrides the tap tempo setting. Pressing Tap
overrides the Time knob setting.
Sub-divisions of the delay time can be selected using a small push button located to the left of the
Time knob. Sub-division values are indicated by three LEDs located above the Time knob. The three
selections are: 1, ¾ and golden ratio (.382) subdivision settings. Pushing and holding the small push
button switch will turn on a second delay tap that can be set to any of the three sub-division values.
The second tap is indicated by a blinking LED. Once the second tap is activated, press the small push
button switch to advance the second tap to a different sub-division. It is possible to have both taps
overlap. Push and hold the switch again to turn off the second tap.
Sets the volume level of the delay signal.
Sets the amount of regeneration in the delay line. Turning this knob fully clockwise will cause the
delay line to self-oscillate.
The function of the Mod knob is selectable with a small push button located above the Mod knob. The
three selections provide control of Speed, Depth, and Tone. Speed sets the rate of LFO modulation
of the delay line. Depth sets the amount of LFO modulation in the delay line. Tone sets the cutoff
frequency of the low pass filter in the delay line. When toggling between these three functions,
the selected parameter will not change in value until the knob is turned. Pushing and holding the
small push button switch will synchronize the LFO speed to the tap tempo value. The default is 1:1.
Adjusting the Speed knob when the LFO is synced will change the ratio between the LFO speed and
tap tempo. Available ratios are: 1:4, 1:3, 1:2, 1:1 (noon), 2:1, 3:1, 4:1. Push and hold the switch again to
turn LFO sync off. The Speed function does not have to be selected in order to turn LFO tempo
sync on and off.
Pressing the Engage footswitch toggles between bypass and effect on.
Time
Mix
Repeats
Mod
Engage Footswitch
Knobs
