PIETRO FIORENTINI ASX 176, Перевод оригинальной инструкции

Страница: 97 / 254

97
ASX 176
Use, maintenance and warning instructions
HIGH PRESSURE REGULATOR | COMMISSIONING | REV. 00
EN
SPRING CALIBRATION FOR MINIMUM PRESSURE TRIP (IF ANY)
Step Action
1
Open the vent (fig.8.11, ref. 6) to the atmosphere and keep it open for the next steps.
2
Decrease the downstream pressure to the minimum tripping pressure of the slam-shut device by adjusting the
pilot.
NOTICE!
Check the pressure referring to the downstream pressure gauge (fig. 8.11, ref. 5).
If the slam-shut valve:
• trips before the expected pressure value: unscrew (anti-clockwise) the adjustment ring nut
(15) so as to relieve the spring (17);
• does not trip before the expected pressure value, screw in (clockwise) the adjustment ring
nut (15) so as to further compress the spring (17).
3
Close the vent (fig.8.11, ref. 6).
4
Balance the upstream and downstream pressure of the slam-shut valve using the HP2/2 bypass valve (fig.8.4,
ref. 7.1).
5 Open the vent again (fig. 8.11, ref. 6).
6 Increase the downstream pressure up to the calibration value by adjusting the main regulator.
7 Reset the slam-shut device by adjusting the lever in the 3/2 valve (fig. 4.1, ref. 8).
8
Check the main regulator for proper calibration.
NOTICE!
The calibration value must comply with the operating limits specified on the plate.
9 Check the minimum pressure spring for proper calibration by repeating steps 2-3-4 at least three times.
10 Close the vent (fig.8.11, ref. 6).
11
Check the maximum pressure spring for proper calibration by repeating steps 2-3-4 of table 8.41 at least three
times.
Tab. 8.58.
COMMISSIONING THE REGULATOR
NOTICE!
Refer to paragraph 8.5 “Regulator commissioning procedure” in this chapter.