PIETRO FIORENTINI ASX 176, Перевод оригинальной инструкции

Страница: 77 / 254

77
ASX 176
Use, maintenance and warning instructions
HIGH PRESSURE REGULATOR | INSTALLATION | REV. 00
EN
If there is a multiple sensing line (see fig. 6.23), provide equipment connections as shown below:
• 1 and 2 to the discharge outlet of the regulator control head and PM/176 monitor if any;
• 3 and 4 to the pilot sensing lines;
• 5 and 6 to the sensing lines of the accelerator and/or of the slam-shut device, if any.
NOTICE!
If there is a multiple sensing line, it is not recommended to place shut-off valves on sensing lines.
In any case, follow the regulations in force in the place of installation and use of the equipment.
5
3
1 2
4
6 5
3
1
2
4
6
Fig. 6.23. Equipment connections
6.6 - POST-INSTALLATION AND PRE-COMMISSIONING CHECKS
When the equipment is operating, make sure that all connections are:
• properly secured/tightened to prevent any leakage during commissioning;
• connected correctly.