www.picoteinstitute.com
Picote Solutions Oy Ltd
13
The optimal rotation speed of the Mini Cleaner and Mini CC is between 2
-
4 (900
-
2100 rpm)
depending on the work.
Minimum rotation speed is usually preferred when moving the tool around
tight bends. When beginning work adjust the speed up to the level which seems to work the best.
Do not use a higher rotation speed than setting 4 (2100 rpm) as it may cause overheating between the shaft and
the outer casing.
This section contains important safety information. Failure to comply could result in serious injury.
Rotation Speed
Speed dial
3200
X
2700
X
2100
X
1500
X
900
X
600
X
1
2
3
4
5
6
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
OPERATING INSTRUCTIONS
The speed dial can be found on the
motor itself (see image right). Set
the speed by rotating the button.
Check the corresponding rotation
speed from the table below.
TIGHTENING THE SET SCREWS
When you add a tool always tighten the screws
starting from the screw furthest away from the
end of the flexible shaft (where applicable).
