IR-transmitters Pico4, Pico8 and Pico16
Page 17
•
IR capture can be done on page 2 even if page 2 is disabled.
•
IR capture can be done on page select key on page 1 even though page 2 is enabled.
If page 2 is enabled, the lower left key will not transmit any IR because it is used as a page
select key.
•
IR capture cannot be done on page select key on page 2.
How to…
•
Each IR signal has to be captured twice.
•
Position Pico4-8-16 and the other IR-transmitter facing each other. It should be about 2-3
cm between the two of them.
•
Press shortly on the key on Pico4-8-16 to be programmed. The key will lit, green light
indicator will lit, yellow page indicator light will flash slowly.
•
Press shortly on the key to capture IR from on the other remote controller. When first IR
signal is captured there will be a short delay, then the green and yellow indicator lights
will flash synchronously.
•
Press shortly on the key on the other remote controller to capture IR from.
When first IR signal is captured, green and yellow indicator lights will flash
synchronously.
•
Press shortly once again on the key on the other remote controller to capture IR from.
When the second IR signal is captured, light in the key will be turned off, green light
indicator will flash 3 times, and then the yellow light indicator continue flashing slowly.
Repeat sequence for other keys as needed.
If the Picomed controller does not receive IR signals within 20 seconds, it will exit to
programming mode. This is indicated by the yellow flashing light indicator. Leave
programming mode as described in chapter 4.1.
5
Pico4 and Pico8 – keypad exchange
Pico4 and Pico8 have alternative keypads.
•
Pico4 (included): keypad with 4 arrows, may be rotated
to point up-down or left-right.
•
Pico8 (included): keypad with arrows, numbers and key-
page select.
•
Pico8 (not included): can combine to keypads from
Pico4, arrows and/or numbers.
