PICOBREW Z SERIES
| 27
Brewing PicoPaks
Make sure your equipment is clean, then follow the steps
below to get started brewing a PicoPak:
01.
From the main menu of your Z, select ‘PicoPaks & Z Kits’
and then ‘PicoPaks’. Alternatively, you can select ‘Recipe
ID’ and enter the 4 digit RID code found on the external
PicoPak box followed by the Check Mark. Select ‘Start’.
02.
Remove the Step Filter Keyhole Plug, retain it for future
brews.
03.
Place the Adjunct Screen in the bottom of the Adjunct
Compartment of the Step Filter, resting on the bottom
ledge. Ensure that the semi-circular cutout matches up
with the Drain Tube indentation. Place the Bottom Mash
Screen into the mash compartment so that it rests on the
bottom ledge of the Step Filter.
04.
Important: you will NOT use the Adjunct Insert, Hops
Cages, or Top Mash Screen when brewing a PicoPak.
05.
Insert the PicoPak Adapter into the step filter. Note that
it goes in the back-most and left-most corner of the
Step Filter, with the built-in hops clamp in the back, see
diagram.
06.
Place the PicoPak Hops Container into the built-in
hops clamp of the PicoPak Adapter. The PicoPak Hops
Container cut corner should face toward the back, see
diagram. Make sure that the tabs of the built-in hops
clamp align with the indentations in the Hops Container
– this will ensure that the Hops Container holes are
properly aligned with the Step Filter Lid holes.
