Pickering PXI 40-785, Руководство пользователя

Страница: 9 / 32

Page (VIII)
MICROWAVE MULTIPLEXER MODULE 40-785
pickering
WARNING
Only the correct SMA connector series should be mated with these modules. The 40-785 range uses
SMA-3.5, SMA-2.9 & SMA-1.8 connectors for 40, 50 & 65GHz respectively, and the user should only mate
the correct type to the module, failure to do so may result in damage to the connector.
Also, it is important that the SMA connector’s nut is properly tightened to the correct torque with a
5/16 inch wrench. This should be 3-5 in·lbs (0.3 to 0.6 N·m) for brass, and 7-10 in·lbs (0.8–1.1 N·m) for
stainless steel connectors.
!
Page (VIII)
2 AMP 1-POLE UHD MATRIX MODULES 40-575 / 576 / 577 / 578 / 579
pickering
CAUTION - PRODUCT DOCUMENTATION SYMBOL
Suitably qualified & trained users should ensure that the accompanying documentation is fully read
and understood before attempting to install or operate the product.
!
SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS
All cleaning and servicing requires the equipment to be isolated and disconnected from the power source and user I/O
signals (refer to the Maintenance Section).
• Appropriate manual handling procedures should be followed as dictated by the weight of the individual module or
the combined weight of the modules & chassis.
• Should a fault occur with the module or chassis, immediately isolate and disconnect the incoming power to the
chassis and the user I/O signals.
• Ensure the equipment is installed, operated and maintained by trained and authorised personnel.
• For suitably equipped products in the event of an emergency press the red “emergency stop” button situated on
the front of the unit.