50mm
50mm
Bergfalke
Rudder control
25mm
15mm
25mm
25mm
50mm
50mm
50mm
Position the canopy so the rear frame on the canopy is
aligned with the rear edge of the cockpit opening. Use
canopy glue to secure the canopy to the canopy hatch.
Use low-tack tape to hold the canopy in position until
the glue fully cures. Wrap the tape completely around
the canopy hatch, as the tape does not stick well to the
covering. We used balsa sticks to hold the lower edges
of the canopy tightly against the canopy hatch.Installing
the fuselage hatch as same as picture below.
9
Aileron:
25mm up
15mm down
Elevator:
25mm up
25mm down (30%Expo)
Rudder:
50mm right
50mm left
© Copyright PICHLER Modellbau
www.pichler-modellbau.de
