3
3
Install the rubber grommets and brass eyelets on to the
aileron servos.
Using a modeling knife, remove the covering from over
the pre-cut servo arm exit hole on the aileron servo tray
/hatch.This hole will allow the servo arm to pass
through when installing the aileron pushrods.
Using the thread as a guide and using masking tape,
tape the servo lead to the end of the thread: carefully
pull the thread out. When you have pulled the servo
lead out, remove the masking tape and the servo lead
from the thread.
Befestigen
Secure
Drill a hole 1.5 mm
1.5 mm
Place the servo into the servo tray. Center the servo
within the tray and drill 1.5mm pilot holes through the
block of wood for each of the four mounting screws
provided with the servo.
Electric wire
Drill a hole 1.5 mm
1.5 mm
2x10mm
Befestigen
Secure
Remove the covering from the slot on the bottom of the
aileron.
Insert the control horn into the slot and secure it by A+B
Epoxy glue.
1.
A/B
glue
5-Min. Epoxy Klebstoff
Epoxy
2. Push in
control horn
Aileron
Aileron Control Horn
Bergfalke
